Low Water Pressure Repair for Homes Across the GTA

Signs it is time to call

Low pressure everywhere points to the main, the meter, the pressure regulator or old galvanized pipe. A single weak fixture typically comes down to a plugged aerator, cartridge or a partly closed stop. High pressure shows up as banging pipes, dripping relief valves and appliance hoses that fail early.

A pressure gauge on a hose bib tells you more than an hour of guessing.

On the job, step by step

1. Gauge the static pressure at a hose bib or laundry tap.
2. Run several fixtures and watch the drop.
3. Check the main valve is fully open and the regulator setting.
4. Inspect aerators, cartridges and stops on problem fixtures.
5. Recommend the fix: regulator replacement, valve, repipe or service upgrade.

GTA houses and what they change

Homes at lower elevations in some parts of the region see higher street pressure and need regulators. Older homes with half-inch galvanized pipe lose pressure from scale. A larger service may be needed for homes with added bathrooms.

• Static pressure tested
• Regulator checked
• Expansion tank where needed

Before you pick up the phone

Ask whether the plumber will measure pressure before recommending anything. Call (365) 387-8531.

Typical cause

Corroded galvanized, pinholes, frozen runs, lead service

Access point

Basement ceiling, access panels, the meter

Proof of fix

Gauge holds, meter stops, joints dry

Related pages

• Gas Line InstallationRepair
• Frozen Pipe ThawingRepair