Skip to content
GTAGTA Plumbing Company

Services ยท Hot water

Tankless Water Heater Installation for Homes Across the GTA

On-demand heaters burn only while water flows. With the right size and venting, it gives steady hot water; sized wrong, it gives disappointment in the shower.

  • Burner, elements, anode and venting checked
  • Relief valve tested on every visit
  • Repair or replace explained side by side
Wall-mounted pipe manifold with several valves and a gauge
A supply manifold with valves and a gauge.

Diagnosis first, tested after

Signs it is time to call

Families who run out of hot water, homeowners finishing basements who want the floor space back, and those leaving a rental tank often consider tankless. It makes most sense where the home has adequate gas supply and a good route for venting.

Tankless is not endless if the gas line is too small to feed it.

On the job, step by step

  1. Calculate peak flow: how many showers and taps run at once, and the winter inlet temperature from Lake Ontario water.
  2. Check gas meter capacity and pipe size; tankless units need far more gas while firing than a tank.
  3. Mount the unit on a wall, run PVC or approved venting to the exterior.
  4. Install isolation valves for annual descaling and a condensate drain on condensing units.
  5. Commission, dial in the temperature and show you the control panel.

GTA houses and what they change

Hard water scales heat exchangers, so annual flushing or a softener is advisable. Older homes may call for upsizing the gas pipe off the meter. Vent terminations have clearance rules near windows, doors and property lines. For some houses, a condensing tank or a combi boiler makes more sense.

TankTankless
Floor spaceLargeWall-mounted
Runs outYes, when emptiedNo, within flow rating
MaintenanceFlush, anodeDescale

Before you pick up the phone

Ask how the unit was sized and whether your gas line is adequate. Call (365) 387-8531.

Signs you need this

  • A puddle at the foot of the heater after each burn cycle
  • Pilot will not stay lit, or elements trip the breaker
  • Hot water runs out halfway through one shower

What is included

  • Combustion and draft checkConfirms the flue is pulling exhaust out of the house
  • MultimeterElectric elements and thermostats tested in place
Typical cause
Sediment, worn anode, failed thermocouple or element
Access point
Burner door, element covers, drain valve
Proof of fix
Full temperature at the furthest tap

Common questions

Is there a delay before hot water arrives?

Yes, a few seconds longer than a tank in some layouts. A recirculation option can shorten it.

Related pages

Call now · (365) 387-8531